Experimental study and optimization of WEDM of Ti-6Al-4V using Taguchi method
Pages : 1686-1691
Download PDF
Abstract
This research work presents influence of process parameters on surface roughness and material removal rate (MRR) while wire electrical discharge machining of titanium grade 5(Ti-6Al-4V). Experiments have been conducted with six process parameters viz., pulse on time, pulse off time, servo voltage, peak current, wire feed rate and wire tension. Taguchi’s orthogonal array (L27) was employed for experimental investigation. ANOVA analysis was used to determine most significant factors affecting the machining performance.
Keywords: Surface roughness, MRR, wire electrical discharge machining, titanium grade 5, Taguchi technique, ANOVA.
Article published in International Journal of Current Engineering and Technology, Vol.6, No.5 (Oct-2016)
MECHPGCON, MIT College of Engineering, Pune, India
AMET, MIT College of Engineering, Pune, India
International Conference on Advances in Mechanical Sciences 
International Symposium on Engineering and Technology
International Conference on Women in Science and Engineering
